Naming inconic compounds and lots of iconic naming

Answer:

167 mL.

Explanation:

We'll begin by calculating the number of moles in 45 g of aluminum (Al). This can be obtained as follow:

Mass of Al = 45 g

Molar mass of Al = 27 g/mol

Mole of Al =?

Mole = mass /Molar mass

Mole of Al = 45/27

Mole of Al = 1.67 moles

Next, the balanced equation for the reaction. This is given below:

2Al + 3H2SO4 → Al2(SO4)3 + 3H2

From the balanced equation above,

2 moles of Al reacted with 3 moles of H2SO4.

Next, we shall determine the number of mole of H2SO4 needed to react with 45 g (i.e 1.67 moles) of Al. This can be obtained as:

From the balanced equation above,

2 moles of Al reacted with 3 moles of H2SO4.

Therefore, 1.67 moles of Al will react with = (1.67 × 3)/2 = 2.505 moles of H2SO4.

Thus 2.505 moles of H2SO4 is needed for the reaction.

Next, we shall determine the volume of H2SO4 needed for the reaction. This can be obtained as follow:

Molarity of H2SO4 = 15.0 M

Mole of H2SO4 = 2.505 moles

Volume =?

Molarity = mole /Volume

15 = 2.505 / volume

Cross multiply

15 × volume = 2.505

Divide both side by 15

Volume = 2.505/15

Volume = 0.167 L

Finally, we shall convert 0.167 L to mL. This can be obtained as follow:

1 L = 1000 mL

Therefore,

0.167 L = 0.167 L × 1000 mL / 1 L

0.167 L = 167 mL

Thus, 0.167 L is equivalent to 167 mL.

Therefore, 167 mL H2SO4 is needed for the reaction.

Answer:

-114kJ mol-1

Explanation:

Definition of the enthalpy change of neutralization: the energy released with the formation of 1 mole of water when neutralization takes place between an acid and a base.

Since both reactions yield the same number of moles of water, the answer should be -114kJ mol-1.

The statement for the enthalpy change of reaction 2 is "-114 kJ"

The change in enthalpy (ΔH) is a quantity of heat of a system. The enthalpy change is the amount of heat that enters or exits a system during a reaction.

One equivalent of hydrogen ions is neutralised with one equivalent of hydroxide ions in the reaction 1,

NaOH(aq) + HCl(aq) → NaCl(aq) + H2O(l)

The change in enthalpy is given as -114 kJ.

Two equivalents of hydrogen ions are neutralised with two equivalents of hydroxide ions in the reaction 2,

Ba(OH)2 + H2SO4 (aq) → BaSO4 (s) + 2H2O (l)

But, that primary ionic reaction is same for both the reaction in which hydrogen ion combines with hydroxide ion to generate a water molecule. So, the enthalpy change of reaction 1 would be exactly same as for reaction 2.

The neutralization enthalpy comes out to be -114 kJ.

Hence the correct answer is -114 kJ.

Learn more about enthalpy change here

https://brainly.com/question/4526346

#SPJ2

Answer:

Watch Naruto that's the answer

Explanation:

Answer:

is highly respect is correct I promise!

Answer:

Trioxocarbonate (iv) are salts derived from trioxocarbonate (iv) acid when it reacts with metals and metallic oxides. All trioxocarbonate (iv) salts of Sodium (Na), Potassium (K) and Ammonium(NH4+) are soluble while all others are insoluble.

Answer:

The magnesium ion is much smaller than the magnesium atom because magnesium atom contains more electrons as compared to magnesium ion. Explanation: ... Whereas when an atom tends to lose an electron then it acquires a positive charge and size of the atom tends to increase.

Answer:

Because it looses it two electrons to form a stable octet Ionic form..........

Answer:

one more time

Explanation:

shpuld i go

Answer:

None. Electrons are not in the nucleus.

Explanation:

We know that an atom consist of electrons, protons and neutrons. Neutrons and protons are present inside the nucleus while electrons are present out side the nucleus. Electron has a negative charge and is written as e⁻. The mass of electron is 9.10938356×10⁻³¹ Kg . While mass of proton and neutron is 1.672623×10⁻²⁷Kg and 1.674929×10⁻²⁷ Kg respectively.

Symbol of proton= P⁺  

Symbol of neutron= n⁰  

The number of electron or number of protons are called atomic number while mass number of an atom is sum of protons and neutrons. The umber of protons and electrons are always equal to make the atom electrically neutral .

The atom having atomic number 16 have 16 electrons and these electrons are present out side the nucleus.

Answer:

Copper, a metal known since ancient times, is used in electrical cables and pennies, among other things. ... Calculate the average atomic mass of copper. ... The atomic masses of the two stable isotopes of boron 10B (19.78%) and 11B (80.22%) are 10.0129 amu ... (.1978)(10.0129 amu) + (.8022)(11.0093 amu) =10.81 amu.

Explanation:

I hope I help :)

The work energy of this process : 2337.298 J

The laws of thermodynamics 1 state that: energy can be changed but cannot be destroyed or created  

ΔU=Q-W

Q=m.c.Δt

[tex]\tt Q=8.85\times 2.650\times 63.2=1482.198~J[/tex]

the work (W) :

[tex]\tt W=Q-\Delta U\\\\W=1482.198-(-855.1)=2337.298~J[/tex]

Answer:

The correct option is the last option (Some dissolved solids may be nonelectrolytes)

Explanation:

Total dissolved solids (TDS) cannot be calculated by conductivity alone because conductivity involves ionic charges and there are solids that dissolve in water but do not carry ionic charges (and thus form non-electrolytes). Examples include sucrose (common sugar) and glucose. These two solids will dissolve in water but would not form ions that will carry ionic charges which are responsible for conductivity. Thus, if TDS only depends solely on conductivity, then a solution that contains dissolved sucrose will be wrongly accounted for as the sucrose will be omitted from the dissolved substances.

A valid reason why total dissolved solids (TDS) cannot be accurately

calculated by conductivity alone because some dissolved solids may be

non-electrolytes.

Conductivity means the ability of electric current to pass through a

substance and an electrolyte has a high conductivity when dissolved in

water.

Dissolved solids can't be measured by conductivity because not all

dissolved solids are electrolytes.

Read more on https://brainly.com/question/19457008

Answer:

7

Explanation:

J.J. Thomson's plum pudding model of the atom followed the discovery of negatively charged particles with a very small mass. Thus, the correct option for this question is A.

J.J. Thomson was a British physicist who discovered sub-atomic particles known as electrons within an atom. He also announced that atoms are made up of smaller components.

The plum pudding model is defined by Thomson in order to demonstrate that negatively charged sub-atomic particles known as electrons are surrounded by a volume of positively charged particles known as protons. It is one of the historical scientific model of the atom that governs all sorts of properties of sub-atomic particles.

Therefore, "negatively charged particles with a very small mass" is the discovery that follows J.J. Thomson's plum pudding model of the atom. Thus, the correct option for this question is A.

To learn more about the Plum pudding model, refer to the link:

https://brainly.com/question/4839193

#SPJ2

Answer:

############################

Explanation:

Answer:

C

Explanation:

Answer:

I think is A

Explanation:

Hope it helps

Answer:

Universe.

Explanation:

Biosphere is just a planet. Solar system contains planets and star. Galaxy holds multiple solar systems only. Universe hold everything, biospheres, solar systems, and galaxies. I hope this helps :D

Answer:

B.

Explanation:

A solar system is IN a galaxy. Its not A.

A Galaxy doesnt have other galaxies in it. Its not c

A biosphere is only referring to earth. its not D.

Therefore, it is B. A universe is everything in outer space including stars, planets, and galaxies.

Answer:

alot of things

Explanation:

Answer:

[tex]T_f=26.7\°C[/tex]

Explanation:

Hello.

In this case, when two substances at different temperature are placed in contact in an isolated container, we can say that the heat lost by the hot substance is gained by the cold substance. In such a way, since granite is at 76.0 °C and water at 22.0 °C we infer granite is hot and water is cold, so we write:

[tex]Q_{granite}=-Q_{water}[/tex]

In terms of mass, specific heat and change in temperature, we write:

[tex]m_{granite}C_{granite}(T_f-T_{granite})=-m_{water}C_{water}(T_f-T_{water})[/tex]

Thus, since the temperature is the same for both substance, we can solve for it as shown below:

[tex]T_f=\frac{m_{granite}C_{granite}T_{granite}+m_{water}C_{water}T_{water}}{m_{granite}C_{granite}+m_{water}C_{water}}[/tex]

By plugging in each variable, we obtain:

[tex]T_f=\frac{11.1g*0.790\frac{J}{g\°C} *76.0\°C+22.0g*4.18\frac{J}{g\°C} *22.0\°C}{11.1g*0.790\frac{J}{g\°C} +22.0g*4.18\frac{J}{g\°C}}\\\\T_f=26.7\°C[/tex]

Best regards!

Answer:

Ionic

Explanation:

Because sulphur is a non-metal and cesium is part of the group 1 Alkali Metals, this creates an ionic bond

Ionic bonds are created from one metal and one non-metal element.

This still is declared as Ionic despite the balance of this is Cs2S

Answer:

idek akxkkwskkd nwkdkekekd

Answer:

Adenine pairs with thymine and guanine pairs with cytosine

Answer:

23 Sandwiches

6 slices of bread

0 slices of cheese

Explanation:

brainliest pls:)

This quantity = 0.298 nanograms(ng)

Mass is one of the principal quantities, which is related to the matter in the object

The main mass unit consists of 7 units of other than other units of mass such as quintals, tons, pounds, ounces:

Kilogram, kg

Hectogram, hg

Decagram, dag

gram, g

Desigram, with

centigram, cg

milligram, mg

Each unit descends then multiplied by 10, and if one unit increases then divided by 10

Conversion of other mass units:

10⁻³ g ⇒mg-milligrams

10³ g ⇒kg-kilograms

10⁻⁶ g ⇒µg-micrograms (mcg)

10⁶ g ⇒Mg-megagrams (tons)

10⁻⁹ g ⇒ng-nanograms

10⁹ g ⇒Gg-gigagram

10⁻¹² g ⇒pg-pikogram

2.98 x 10⁻¹⁰ g to nanograms(ng)

[tex]\tt 2.98\times 10^{-10}\times 10^9=0.298~ng[/tex]

Answer:

Increases

Explanation:

The gravitational potential energy of an object increases as you bring it higher with respect to the ground.

Gravitational potential energy depends on the mass, height and gravity between two bodies;

   Gravitational potential energy  = mgh

m is the mass

g is the height

h is the height